uart_2ndstage=1

# Uncomment to mark the EEPROM as write protected when the EEPROM /WIP pin is pulled low.
# See https://www.raspberrypi.com/documentation/computers/raspberry-pi.html#eeprom-write-protect
#eeprom_write_protect=1

# Uncomment to write to enable secure-boot by writing. This
# locks the device to the public key in the EEPROM by storing the
# sha256 hash of the public key in OTP.
#
# This option also prevents the ROM from loading recovery.bin from SD/EMMC
# which means that the bootloader can only be updated via RPIBOOT or self-update.
#
# recovery.bin version to 2025-05-16 and newer automatically sets
# revoke_devkey=1 if program_pubkey is non-zero.
#
# Uncomment program_pubkey=1 to enable this
# WARNING: THIS OPTION MODIFIES THE BCM2711 CHIP AND IS IRREVERSIBLE.
#program_pubkey=1

# Pi 4B and Pi400 do not have a dedicated RPIBOOT jumper so a different GPIO
# must be used to enable RPIBOOT if pulled low. The options are 2,4,5,6,7,8.
#
# This option has no effect on CM4.

# WARNING: THIS OPTION MODIFIES THE BCM2711 CHIP AND IS IRREVERSIBLE.
#program_rpiboot_gpio=6

# Permanently disable VideoCore JTAG access.
# Warning: This option limits the ability to do failure analysis on
# boards returned to resellers or Raspberry Pi Trading Ltd.
#program_jtag_lock=1

# rpiboot - only
# If recovery_reboot is set then the Pi will disconnect USB and
# reboot after the flashing the firmware.
#recovery_reboot=1

# Uncomment to instruct recovery.bin to stop sending metadata
#recovery_metadata=0
